Safety Information; Assembly/Mounting - Led2Work Leanled Ii Basic-Line Betriebsanleitung

BA LEANLED II Basic-Line

3 | Safety information

4 | Assembly / Mounting
Check the LED light before installation to ensure it is complete and shows no signs of damage. Do not use the light or
accessories if they are damaged, as there is a risk of injury.
The LED light comes fully assembled. The light is attached via the two included luminaire holder sets
option there are this mounting accessories:
Spring clip, steel galvanized, pair
Spring clip with magnet, pair
Light holder set (spare part)
Light holder Mounting adapter for mounting set 210200-18, 1 pair
Light holders, stainless steel (V2A), 1 pair
Installation of electrical equipment may only be carried out by qualified electricians.
Follow the five safety rules according to DIN VDE 0105. Failure to do so may result
in damage to the LED light, as well as fire or other hazards.
Danger of electric shock!
Disconnect before working on the device or load. Ensure to disconnect all circuit breakers
that supply dangerous voltages to the device or load, when doing so. Even when the
device is switched off, the load is not galvanically isolated from the mains.
Only use the device if it is completely free of faults, and with safety and awareness in
mind. If warnings or symbols are attached to the light, they must not be removed.
When mounting the light, make sure that the luminaire is fastened securely and stably. If
the light falls down, its weight poses a risk of injury!
2
and
Product no.
210200-07
210200-08
210200-18
210200-19
210200-34
www.led2work.com | shop.led2work.com
3
. As
| 11