PROPAIN TRICKSHOT Aufbauanleitung / Betriebsanleitung Seite 71

Vorschau ausblenden Andere Handbücher für TRICKSHOT:

Seite von 193

/ 193
Inhalt
Inhaltsverzeichnis
Lesezeichen

Inhaltsverzeichnis

// USER MANUAL

7.2

TRANSPORT ON THE CAR REAR OR ROOF RACK

Rear and roof racks with retaining claws for the top, bottom or seat tube are not suitable for carbon frames. The clamping force of the retaining claw can damage the carbon structure. Rims must be padded

before lashing straps or ratchet systems are attached. If several bicycles are transported on the rear or roof rack, care must be taken to ensure adequate spacing or sufficient padding between the bicycles.

When transporting bicycles with carbon wheels on the rear carrier, make sure there is sufficient distance between the exhaust and the wheel. The minimum distance is 45 cm behind the exhaust and at least

20 cm above it. Please also refer to the operating instructions of the rear or roof rack manufacturer.

7.3

BIKE STORAGE

The bicycle should be parked in a suitable bicycle stand, which ideally only holds the rear wheel. Make sure to check the tire pressure when the bike has stood for a long

time. You should not park your bike for longer with no air in the tires. Another alternative for safe storage is to hang the bike on a padded, or

plastic or rubber covered hook. If you use a tubeless system, you should remove the sealant from the tire when

parking your bike longer than three months. Some sealing fluids contain corrosion-

intensifying ingredients and can thus damage the rim.

7.4

SHIPPING THE BIKE

Depending on the size of the PROPAIN bike box, the bike can be shipped

in different assembly states. Ship the bike in the assembly condition as you

received it.

1. Fix or adequately sheathe all loose or moving parts.

→ Sharp or pointed components must be additionally sheathed to prevent them from

causing damage inside the carton and from penetrating to the outside.