Bellezza Francesca Bedienungsanleitung Seite 24

If something does not work
Coffee flows too quickly, little and very light crema
Coffee powder has been
ground too coarsely
Boiler temperature set too low
Coffee / Water is not hot
If the temperature and pressure
are still low, the preheating time
has not yet ended
Boiler temperature set too low
The machine is calcified
There is no or too little steam
If the temperature and pressure
are still low, the preheating
time has not yet ended
When it reaches operating
temperature, the steam pipe
may be clogged
24 32
Seta finer grinding
degree.
Increasethe boiler
temperature.
Wait until the operating
temperature is reached.
Increase the boiler
temperature.
Descalethe machine
Wait until the operating
temperature is reached.
Close the steam valve,
unscrew the steam nozzle
and clean or replace it.
The display shows an error
F3 Not enough water in the
tank or the water tank is
not correct.
EI Steamtemperature
sensor fault
E2 The drawing time is longer
than 2 minutes
The pump was active and
E3
pumped for more than
15 minutes or the
solenoid valve for filling
the boiler is defective
Water temperature sensor
E4
fault
code
Fill the water tank and
the correct position.
Do not operate the machine
below 0 C ambient
temperature.
Pleasecontact your specialist
dealer.
Stop dispensing: To do this,
move the dispensing lever
down.
Switch the on / off switch
off and on again.
If the fault persists, please
contact your specialist
Do not operate the
machine below 0 0 C
ambient temperature.
Pleasecontact your
specialist dealer.
Bellezza I Espressomachines
check