Connect The Machine Electrically; Prepare The Machine - Bellezza Francesca Bedienungsanleitung

Setup and connect the machine
Connect the machine
Make sure that the values
frequency specified on the type plate match the mains at the
installation site.
Only connect the machine to an earthed mains socket. If you
are unsure, contact an electrician or your dealer.
Insert the power plug into the socket.

Prepare the machine

Fill the water tank and connect
Open the cover (Fig. 2: 16) and remove the water tank.
I.
Clean the water tank with hot water and a little washing-up
2.
liquid.
Put the water tank down, fill it with clear, cold water up to
3.
the maximum level and close the cover again.
Connect the water tank adapter to the back of the machine
4.
and screwit tight.
Now connect the water hose to the adapter and the water
5.
tank.
12 32
electrically
for the mains voltage and mains
it
Clean portafilter and tamper
Also clean the two portafilter and the tamper before first
Checktemperatures / Preheat
When you have started the machine, you can use the +
and - buttons to display the various boiler temperatures.
Thewater temperature is displayed by default. With a click
on the "-" button you can seethe steam temperature. If
you click the "+" button, the water temperature is
displayed again. To switch off the preheating of the steam
boiler, you can pressthe "+" button for 5 secondswhile the
steamtemperature is displayed, then the preheating of the
steam boiler is deactivated (this is shown with "OFF"on
your display. To reactivatethe preheating, hold down)
Pressthe "+" button again for 5 seconds
Use softened water. This will prevent the machine from
calcifying prematurely.
Do not use pure or distilled water!
Bellezza I Espressomachines