Clean the machine
Clean the shower
screen and group seal
The shower filter and the group seal are located in the portafilter
holder of the brew group. The shower sieve presseson the
powder compacted in the portafilter and distributes the water
pressedin with pressure evenly over the powder surface. The
group seal sealsthe edge of the portafilter used against the brew
group. Constant contact with the coffee powder can
contaminate
the sieveand
seal and should
at regular intervals.
1.
Removethe portafilter and place
a container
under
the brew
group.
2.
Use the
brush
included
in the
scopeof delivery to remove
coffee
residuesand
encrustations
from
the
sieveand
the
seal.
3.
Use the reference leverto briefly
start the pump to rinse out the
brushed-off
parts.
Depending on the frequency of use, the shower strainer and
group seal should be replaced after a few years. Information
on this can be found in the section "Changing the shower
filter and group seal" on page 25.
20
32
Clean the housing
electric shock. Serious injuries and damage to the machine and
can
therefore
be cleaned
A ATTENTION
There
WARNING
Electric
shock
Liquids that get into the machine can causea short circuit and
result.
Only clean the machine when it is switched off. Also
disconnect the machine from the power supply.
Make sure that no liquids get inside the machine.
If liquids got inside the machine during cleaning, do not
connect the machine to the power supply and do not switch
it on. Depending on the amount of liquid that has entered,
wait until it has evaporated again. Contact your specialist
dealer if you are not sure.
Riskof
burns
Partsof the machine can still be hot even after switching off.
is a risk of bums
if touched!
Only clean the machine when it is switched off.
After switching off the machine, wait until all parts have
cooled down sufficiently.
Bellezza I Espressomachines