Parking Brake - Timago Neuro-Tim Benutzerhandbuch

so that the angle between trunk and thighs is 90
for the user).
Step 4. Adjustment of an�-�p wheels
To install an�-�pping wheels push them into openings located at the back of the
wheelchair and secure with locking pin clips. To adjust them, take out the locking
clip and select appropriate length, securing them a�erwards.
Step 5. Assembly of headrest
Atach the headrest to the backrest by inser�ng it into the moun�ng openings.
Then, press the locking pins located on the inside of the frame and push the
headrest down un�l you hear a clicking sound.
Step 7. Assembly of upholstery
Place the upholstery on the seat and secure with velcros.
The wheelchair is ready to use.
FOLDING
The wheelchair can be re-folded for easier transporta�on and storage.
• Swing the footplates away and place them in a ver�cal posi�on, or remove
them completely.
• Detach the upholstery and headrest.
• Press down the red switch located on the push bar behind the backrest (see
picture 1) to fold the bar.
• Pull the seat upwards from the front and back to fold the wheelchair.

PARKING BRAKE

• To lock the wheels, push the parking lever forward un�l the wheel is fully
blocked (separately for the le� and right wheels). Please note that the
parking brake only serves to lock the wheels when the wheelchair is
completely sta�onary.
• The atendant brakes are equipped with parking locks. To use them, pull the
parking brake levers (E). To unlock the brake, press the red switch located
under the levers.
PARKING BRAKES ADJUSTMENT
The proper func�oning of the parking brake depends on its adjustment and
posi�on. It should be mounted in adequate distance from the back wheel, so that
it is blocked firmly and the lever does not face excessive resistance.
• In case of excessive resistance, move the parking brake towards the front
using the locking screws. Set the parking brake in a posi�on that allows it to
block the wheels easily and without excessive resistance.
0
35
(op�mum si�ng posi�on