Raddy N80 Handbuch Seite 6

N80 Manual
indicating that the pairing process is complete.
step4 step5
step1 step2 step3
Note: The paired WIFI hotspot must be 2.4GHz, this product only supports 2.4GHz wireless network
 If the main unit does not automatically enter the pairing mode when powered on for the first time, you can
press and hold the " " button for more than 3 seconds to enter the pairing mode manually, the display
prompt is the same as the automatic entry.
 After the pairing is completed, the weather station will automatically connect to the WLAN, automatically
update the network time, and start searching for signals from remote wireless sensors. The " " icon blinks
for about 3 minutes. At this time, if the outdoor wireless sensor is working normally, the main unit will start to
search for the signal of the remote wireless sensor within 1-2 minutes. Once it detects the signal, the outdoor
temperature and humidity will be displayed on the main unit's screen.
Outdoor Sensor Transmission:
 The main unit supports registration of up to 3 channels for wireless sensors. When using multiple wireless
sensors, ensure each sensor is assigned a unique channel (Channels 1, 2, or 3). Avoid selecting the same
channel for more than one sensor simultaneously.
 Press the " " button to switch outdoor temperature | humidity between different channels.
 If the main unit cannot receive the transmission signal from the outdoor sensor ("- -" is displayed on the LCD),
press and hold the " " button for 3 seconds to receive the transmission signal manually. The outdoor
temperature will show the RF antenna icon flashing, and the main unit will re-receive the wireless signal from
the outdoor sensor.
Note: when the wireless sensor set up different channels, the base station also need to switch to the same
channel. When there is no wireless sensor signal transmission on the channel, "--"will be displayed in the
channel of the base station. Please note that the channel of the sensor and the base station should be
consistent.
6