General Instructions - Helix Next V Two Bedienungsanleitung

Congratulations!
Dear Customer,
Congratulations on your purchase of this innova-
tive and high-qual ity HELIX product.
Thanks to more than 35 years of experience in
research and development of audio products this
amplifier sets new standards in the range of am-
plifiers.

General instructions

General installation instructions for HELIX
components
To prevent damage to the unit and possible injury,
read this manual carefully and follow all installa-
tion instructions. This product has been checked
for proper function prior to shipping and is guaran-
teed against manufacturing defects.
Before starting your installation, disconnect
the battery's negative terminal to prevent
damage to the unit, fire and / or risk of injury.
For a proper performance and to ensure full war-
ranty coverage, we strongly recommend to get this
product installed by an authorized HELIX dealer.
Install your HELIX V TWO in a dry location with
sufficient air circulation for proper cooling of the
equipment. The amplifier should be secured to
a solid mounting surface using proper mounting
hardware. Before mounting, carefully examine the
area around and behind the proposed installation
location to insure that there are no electrical ca-
bles or components, hydraulic brake lines or any
part of the fuel tank located behind the mounting
surface. Failure to do so may result in unpredict-
able damage to these components and possible
costly repairs to the vehicle.
We wish you many hours of enjoyment with your
new HELIX V TWO.
Yours,
AUDIOTEC FISCHER
General instruction for connecting the HELIX
V TWO amplifier
The HELIX V TWO amplifier may only be installed
in vehicles which have a 12 Volts negative termi-
nal connected to the chassis ground. Any other
system could cause damage to the amplifier and
the electrical system of the vehicle.
The positive cable from the battery for the com-
plete system should be provided with a main fuse
at a distance of max. 30 cm from the battery. The
value of the fuse is calculated from the maximum
total current input of the car audio system.
Use only suitable cables with sufficient cable
cross section for the connection of the HELIX
V TWO. The fuses may only be replaced by
identically rated fuses (3 x 30 A) to avoid dam-
age of the amplifier.
Prior to installation, plan the wire routing to
avoid any possible damage to the wire harness.
All cabling should be protected against possible
crushing or pinching hazards. Also avoid routing
cables close to potential noise sources such as
electric motors, high power accessories and other
vehicle harnesses.
en
15