Behringer D Kurzanleitung Seite 41

8. Securely connect the 16-pin end P2 of the supplied
adapter cable to your power supply, and double
check all connections are correct.
9. Securely install the MODEL D Synthesizer into your
Eurorack, using 8 screws in the front panel.
10. Perform a full test and safety test before using
the MODEL D.
11. The 3.5 mm MAIN OUT connector on the top panel
is used instead of the 1/4" rear outputs which are no
longer present.
Setting the MIDI Channel
Once installed in a Eurorack, the MIDI channel number is
automatically set to channel 1 (as the MIDI switches are no
longer present.)
The MIDI channel can be changed using MIDI OX or a
similar MIDI utility on your computer to send MIDI SysEx
commands directly to the MODEL D via the USB MIDI
connection. Here is a brief guide to the procedure (see the
MIDI SysEx pages in this manual for the actual SysEx codes
sent to the MODEL D):
1. Disable the MIDI Channel Switches by sending
the appropriate SysEx command.
2. Change the MIDI Channel by sending
the appropriate SysEx command.
FACE-PRIN-PH1_QSG_BE_0718-AAC_MODEL D_A5_WW_PRINT_2024-06-24_Rev.7.indd 41 FACE-PRIN-PH1_QSG_BE_0718-AAC_MODEL D_A5_WW_PRINT_2024-06-24_Rev.7.indd 41
41
Quick Start Guide
6/24/2024 2:25:49 PM 6/24/2024 2:25:49 PM