VEVOR RTD-23A Bedienungsanleitung Seite 9

9. Remove the faulty bulb. Insert a new bulb back inside the small box,
close the lid, and tighten the two screws on the lid. See Fig. 6a & 6b.
10. Reattach both lines and tighten the screws of the box. See Fig. 7a &
7b.
11.Replace Glass Fibre and reattach back panel.
TROUBLESHOOTING
1. There is excessive moisture when the towel warmer is ON or the towels
are heating up very slowly.Check to see that the towels are only slightly
damp. Excess moisture and/or slow heating time may be a result of soaked
towels.
2. The door is not closing properly and/or steam is escaping Check that the
silicone door seal is in place. Push into door groove to assure proper fit.
- 8 -