Toro Flex-Force Power System Bedienungsanleitung Seite 126

Problem
The tool does not start.
The tool does not reach full
power.
The tool does not run or
does not run continuously.
Possible Cause
1. The battery is not fully
installed in the tool.
2. The battery pack is not
charged.
3. The battery pack is
damaged.
4. There is another
electrical problem with
the tool.
1. The battery pack charge
capacity is too low.
2. The air vents are
blocked.
1. There is moisture on
the leads of the battery
pack.
2. The battery is not fully
installed in the tool.
3. The battery pack is low
on charge.
22
Corrective Action
1. Remove and then
replace the battery into
the tool, making sure
that it is fully installed
and latched.
2. Remove the battery
pack from the tool and
charge it.
3. Replace the battery
pack.
4. Contact an Authorized
Service Dealer.
1. Remove the battery
pack from the tool and
fully charge the battery
pack.
2. Remove the battery
pack from the tool and
clean the air vents.
1. Allow the battery pack
to dry or wipe it dry.
2. Remove and then
replace the battery in
the tool, ensuring that
it is fully installed and
latched.
3. Charge the battery
pack.