ZANKER KOB57602 Benutzerinformation Seite 19

3
3
Close the oven door
halfway to the first
opening position. Then
pull forward and remove
the door from its seat.
5
5
Release the locking
system to remove the
glass panels.
7
2
1
7
First lift carefully and
then remove the glass
panels one by one. Start
from the top panel.
Clean the glass panels with water and soap. Dry the
glass panels carefully.
When the cleaning is completed, install the glass panels
and the oven door. Do the above steps in the opposite
sequence.
Make sure that you put the glass panels (A, B and C)
back in the correct sequence. The middle panel (B) has
a decorative frame. The screen-printing zone must face
the inner side of the door. Make sure that after the
installation the surface of the glass panel frame (B) on
the screen-printing zones is not rough when you touch
it.
4
4
Put the door on a soft
cloth on a stable surface.
6
90°
6
Turn the two fasteners by
90° and remove them
from their seats.
A B C
Make sure that you install the middle panel of glass in
the seats correctly.
Replacing the lamp
Put a cloth on the bottom of the interior of the appliance.
It prevents damage to the lamp glass cover and the
cavity.
Warning! Danger of electrocution!
Disconnect the fuse before you replace
the lamp.
The lamp and the lamp glass cover can
be hot.
Caution! Always hold the halogen lamp
with a cloth to prevent grease residue
from burning on the lamp.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or deactivate
the circuit breaker.
19