Cleaning The Oven Door; Replacing The Lamp - ZANKER KOB55602XK Benutzerinformation

1
Install the shelf supports in the opposite sequence.

Cleaning the oven door

The oven door has two glass panels. You can remove
the oven door and the internal glass panel to clean it.
The oven door can close if you try to
remove the internal glass panel before
you remove the oven door.
Caution! Do not use the appliance
without the internal glass panel.
1
1
Open the door fully and
hold the two door hinges.
3
3
Close the oven door
halfway to the first
opening position. Then
pull forward and remove
the door from its seat.
16
2
2
2
Lift and turn the levers on
the two hinges.
4
Put the door on a soft
cloth on a stable surface.
2
B
Hold the door trim (B) on the top edge of the door at the
two sides and push inwards to release the clip seal. Pull
the door trim to the front to remove it.
Hold the door glass panel by its top edge and carefully
pull it out. Make sure the glass slides out of the supports
completely.
Clean the glass panel with water and soap. Dry the
glass panel carefully.
When the cleaning is completed, install the glass panel
and the oven door. Do the above steps in the opposite
sequence.
The screen-printing zone must face the inner side of the
door. Make sure that after the installation the surface of
the glass panel frame on the screen-printing zones is
not rough when you touch it.
Make sure that you install the internal glass panel in the
seats correctly.

Replacing the lamp

Put a cloth on the bottom of the interior of the appliance.
It prevents damage to the lamp glass cover and the
cavity.
1
A