Cleaning The Oven Door - ZANKER ZKB7630 Benutzerinformation

1
Pull the front of the
shelf support rail away
from the side wall.
Hold the rear shelf run-
ners and catalytic panel
in place with the other
hand.
Installing the shelf support rails
Install the shelf support rails in opposite sequence.
The rounded ends of the shelf support rails must
point to the front!
Oven lamp
Warning! Be careful! There is the risk of
electrical shock!
Before you change the oven lamp:
• Switch off the oven.
• Remove the fuses in the fuse box or switch off the
circuit breaker.
Put a cloth on the bottom of the oven for protec-
tion of the oven light and glass cover.
1. Turn the glass cover anti-clockwise to remove it.
2. Clean the glass cover.
3. Replace the oven light bulb with applicable 300°C
heat-resistant oven light bulb.
Use the same oven lamp type.
4. Install the glass cover.

Cleaning the oven door

The oven door has three panels of glass. You can re-
move the oven door and the internal panels of glass to
clean them.
The oven door can close if you try to remove the
panels of glass before you remove the oven
door.
2
1
2
Pull the rear shelf
support rail away from
the side wall and remove
it
Removing the oven door and the glass panel
1
Open the door fully
and hold the two door
hinges.
3
Close the oven door
to the first opening posi-
tion (halfway). Then pull
forward and remove the
door from its seat.
5
Release the locking
system to remove the
panels of glass.
2
Lift and turn the lev-
ers on the two hinges.
4
Put the door on a soft
cloth on a stable surface.
90°
6
Turn the two fasten-
ers by 90° and remove
them from their seats.
33