Safety Information For The Installer - Sentiotec Rb 2,5 Kw Montage- Und Gebrauchsanweisungen

Instructions for installation and use

2.2. Safety information for the installer

● Installing and connecting the auxiliary evaporator may only be
performed when the power supply is disconnected.
● Installation may only be performed by a qualified electrician or
similarly qualified person.
● An all-pole disconnecting device with full cut-off must be fitted
on-site in accordance with overvoltage category III.
● Always use silicone cables that are heat-resistant up to 150 °C
to connect the auxiliary evaporator.
● The roof and walls of the sauna cabin are manufactured from
low-resin, untreated or thermally treated wood, e.g. Nordic spruce,
hemlock, pine or fir, or from laminated wooden materials. If lami-
nated wooden materials are used, make sure that the adhesive
used in them does not produce formaldehyde. If other materials
apart from wood are used in the sauna cabin, these materials
must be heat and corrosion-resistant and must not have any
negative effect on the health of the sauna users.
● When installing the auxiliary evaporator R, observe the minimum
safety distances (see 4.2. Safety distances on page 10).
● Observe all the local regulations applicable to the installation.
● For your own safety, consult your supplier in the event of prob-
lems that are not explained in sufficient detail in the installation
instructions.
p. 6/26