Bluetooth Device - Sony RSX-GS9 Bedienungsanleitung

Pairing and connecting with a

BLUETOOTH device

When connecting a BLUETOOTH device for the first
time, mutual registration (called "pairing") is
required. Pairing enables this unit and other devices
to recognize each other.
1
Place the BLUETOOTH device within 1 m
(3 ft) of this unit.
2
Press and hold  on the unit for more
than 2 seconds.
Alternatively, press and hold MENU on the
remote commander, select [BT Setting] 
[Pairing], then press ENTER.
The BLUETOOTH indicator on the unit flashes
(while the unit is in pairing standby mode).
3
Perform pairing on the BLUETOOTH
device so it detects this unit.
4
Select [RSX-GS9] shown in the display of
the BLUETOOTH device.
If your model name does not appear, repeat
from step 2.
5
If passkey* input is required on the
BLUETOOTH device, input [0000].
* Passkey may be called "Passcode," "PIN code,"
"PIN number" or "Password," etc., depending on
the device.
Input passkey
[0000]
When paired, the BLUETOOTH indicator on the
unit stays lit.
6
Select this unit on the BLUETOOTH device
to establish the BLUETOOTH connection.
10
GB
Note
While connecting to a BLUETOOTH device, this unit
cannot be detected from another device. To enable
detection, enter the pairing mode and search for this
unit from another device.
To start playback
For details, see "Playing a BLUETOOTH Device"
(page 14).
To cancel pairing
Perform step 2 to cancel the pairing mode after this
unit and the BLUETOOTH device are paired.
Connecting with a paired BLUETOOTH
device
To use a paired device, connection with this unit is
required. Some paired devices will connect
automatically.
1
Press and hold MENU on the remote
commander, select [BT Setting]  [BT
Signal], then press ENTER.
Make sure the BLUETOOTH indicator on the unit
lights up.
2
Activate the BLUETOOTH function on the
BLUETOOTH device.
3
Operate the BLUETOOTH device to
connect to this unit.
To connect the last-connected device from
this unit
Activate the BLUETOOTH function on the
BLUETOOTH device.
Press SOURCE (SRC), then select [BT Phone]* or [BT
Audio].
Press ENTER to connect with the cellular phone, or
PAUSE to connect with the audio device.
* Available only when the "Sony | Music Center"
connection is established.
Note
While streaming BLUETOOTH audio, you cannot
connect from this unit to the cellular phone. Connect
from the cellular phone to this unit instead.
Tip
With BLUETOOTH signal on: when the ignition is turned
to on, this unit reconnects automatically to the last-
connected cellular phone.
To install the microphone
For details, see "Installing the microphone"
(page 33).