Environment Protection - Pcl App570Set Anweisungen

• DO NOT use any liquids to clean the tool. Vacuum or dust with a clean rag will be sufficient.
• Keep the work area clean and well lit.
• Follow all workshop safety rules, regulations, and conditions when using the sander.
• Keep children and non-essential persons away from the working area.
• WARNING! DO NOT chisel into any materials containing asbestos.
• DO NOT carry the tool with your hand on the trigger to avoid unintentional starting.
• DO NOT use oxygen or any other combustible or bottled gas to power air-powered tools. Failure to
observe this warning can cause explosion and serious personal injury or death. Use only compressed
air to power the air-powered hammer.
• Locate the compressor in a well-ventilated area for cooling and must be a minimum of 12" (31cm)
away from the nearest wall. Ensure the airline has a filtration device fitted.
• DO NOT use whilst using ladders or steps.
• When not in use, store in a safe, clean, dry, childproof place.
• WARNING! The warnings, cautions and instructions in this manual cannot cover all possible
conditions and situations that may occur. It must be understood by the operator that common sense
and caution are factors which cannot be built into this product but must be applied by the operator.
• Note: It is our policy to continually improve products and as such we reserve the right to alter data,
specifications and component parts without prior notice.
• Important: No Liability is accepted for incorrect use of this product.

2. ENVIRONMENT PROTECTION

Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging
should be sorted, taken to a recycling centre and disposed of in a manner which is compatible with the
environment. When the product becomes completely unserviceable and requires disposal, drain any fluids
(if applicable) into approved containers and dispose of the product and fluids according to local
regulations.
3. SPECIFICATIONS
Stroke length:
Maximum Pressure:
Chisel Shank:
Air inlet:
Weight:
Vibration:
Chisel Dia:
Sound:
Free Speed:
76592 Issue 1
67 mm (1-5/8")
90 psi (6.2 bar)
10.2 mm (0.401")
1/4" BSPT
1.86 kg
4.84 m/s
12.7 mm
96.3 dBa
2,900 bpm
www.pclairtechnology.com