Replacing The Lamp - Sony VPL-ES2 Kurzreferenz

Replacing the Lamp

Notes
• Use LMP-E180 (VPL-CS7) / LMP-E150
(VPL-ES2) Projector Lamp as the replacement
lamp. Use of any other lamps than the LMP-
E180 or the LMP-E150 may cause damage of
the projector.
• Be sure to turn off the projector, and
disconnect the AC power cord from the AC
outlet before replacing the lamp.
Caution
The lamp becomes a high temperature after
turning off the projector with the I/1 key. If you
touch the lamp, you may scald your finger.
When you replace the lamp, wait for at least
an hour for the lamp to cool.
Notes
• If the lamp breaks, consult with customer
service center.
• Pull out the lamp by holding the handle. If you
touch the lamp, you may be burned or injured.
• When removing the lamp, make sure it
remains horizontal, then pull straight up. Do
not tilt the lamp. If you pull out the lamp while
tilted and if the lamp breaks, the pieces may
scatter, causing injury.
1
Turn off the projector, and disconnect
the AC power cord from the AC outlet.
2
Place a protective sheet (cloth) beneath
the projector. Turn the projector over so
you can see its underside.
Note
Be sure that the projector is stable after
turning it over.
3
Open the lamp cover by loosening a
screw with the Phillips screwdriver.
8
GB
Replacing the Lamp
Note
For safety sake, do not loosen any other
screws.
4
Loosen the two screws on the lamp unit
with the Phillips screwdriver (1). Fold
out the handle (2), pull out the lamp
unit by the handle (3).
5
Insert the new lamp all the way in until
it is securely in place. Tighten the two
screws. Fold the handle.
Notes
• Be careful not to touch the glass surface of
the lamp.
• The power will not turn on if the lamp is
not secured properly.