hanseatic SY-103E11 600 Gebrauchsanleitung Seite 35

Installation
2. Install the hanging screw on a suitable place once the installation height is
fixed, and keep it in line. The fixed position of the inside chimney bracket is
the place of chimney. Also install the safety hole in the wall. Total drill 8 holes
and insert the Wall plug.
3. Hang the cooker hood on wall.
4. Use 2 screws (4x30mm) to fix the safety locks in the cooker hood on the wall.
And attach the exhaust pipe on the way wall valve as shown below.
5. Put the inner chimney inside the outer chimney. Install the inner chimney
bracket on the outer chimney by two screws (4x8mm).
6. Put the installed chimneys on the cooker hoods. Fix the outer chimney to the
cooker hood by 2 screws (4x8mm), then fix the outer chimney bracket to the
wall by using 2 screws (4x40mm) and wall plugs. .
7. Lift up inner chimney on the wall. Fix the inner chimney to the inside
chimney bracket by using 2 screws (4x8mm). The same operation to the
outer chimney.
Failure to install the screws or fixing device in accordance with these
Warning
instructions may result in electrical hazards
12
Preparation
Upper chimney facing
External metal plate
Lower chimney facing