Product Usage; Getting Started; Operating Steps; Main Interface - Autool As501 Übersetzung Der Originalanleitung

PRODUCT USAGE

Getting Started

● After opening the back cover of the device, insert two AA
1.5V batteries into the battery compartment, ensuring
correct placement of the positive and negative terminals.
Press and hold the power button [
on the machine. It will emit three beeps, indicating the
device has started up normally.

Operating Steps

● Press and hold the power button [
on the device. Press the backlight button [
screen backlight on and off.
● On the main interface, use the switch button [
the "Brake Fluid" category.
● Brake Fluid Testing: There are six options available: DOT3,
DOT4, DOT5, DOT5.1, ENV4, and ENV6. You can select
the corresponding type of brake fluid for testing.
● Place the probe into the fluid to be tested, ensuring it is fully
submerged.
●
According to the on-screen instructions, press the start
button [
the screen will display the water content and fluid grade.
●
If you need to retest after the test is completed, simply
press the start button [
●
After use, press and hold the power button [
seconds to turn off the device. If the device will not be used
for an extended period, remove the dry batteries and store
them in a safe, dry place.

Main Interface

●
After powering on, the device enters the main interface,
which includes six brake fluid modules: DOT3, DOT4,
DOT5, DOT5.1, ENV4, and ENV6.
] again to begin testing. After about 10 seconds,
] for 3 seconds to turn
] for 3 seconds to turn
] again to perform a new test.
7
] to toggle the
] to select
] for 3