Troubleshooting - Sony VRD-P1 Bedienungsanleitung

Troubleshooting

If you experience any of the following
difficulties while using the unit, use this
troubleshooting guide to help remedy the
problem before requesting repairs. Refer
also to the operating instructions of your
Handycam . If the problem persists,

contact your Sony dealer.
The Handycam
unit does not work.
Make sure that your Handycam

by this unit (page 7).
Make sure that the Handycam

to a power outlet by its AC adapter.
Make sure that the Handycam

correctly and the USB cable is connected
properly to the Handycam
Disconnect the USB cable from the

Handycam . Turn off the Handycam

then turn it on again. Then connect the USB
cable to the Handycam
Video cannot be recorded to the disc.
Video recorded using the

button on the Handycam
using the
same disc cannot be created again using the
(DISC BURN) button.) To create copies of the
same disc, select the [DISC BURN OPTION]
setting on the Handycam
Make sure that the disc is compatible with this

unit (page 7).
Make sure that the disc is new or unused.

A disc that has already been recorded on or
formatted by another device cannot be used.
Make sure that the disc has no dust, dirt or

fingerprints on the recording side.
Make sure that the disc is placed on the disc

tray with its recording side down.
Vibration of the unit may cause a malfunction

of the Handycam
Handycam

1
GB
 is connected, but the
is supported

is connected

is configured

 .
again.

(DISC BURN)
cannot be recorded

(DISC BURN) button again. (The
.

. Do not place the

on the unit.
A disc cannot be played.
You can play back only discs created by this

unit. You cannot play back discs recorded on
other video devices, or commercially pre-
recorded discs.
Make sure that the disc has no dust, dirt or

fingerprints on the playback side.
Make sure that the disc is placed on the disc

tray with its playback side down.
The disc cannot be ejected.
The  (eject) button does not work.
Disconnect the USB cable from the

Handycam
Handycam
the USB cable to the Handycam
press the  (eject) button. If this does not
work, open the disc tray using the emergency
, and

eject hole (page 9).
The unit can open its disc tray only when it

is connected to the Handycam
that the unit is connected to the Handycam
properly.
Make sure that the Handycam

to a power outlet using an AC adapter.
The disc cannot be ejected while recording or

playing a disc.
, turn off the power of the

, then turn it on again, reconnect

, and then

. Make sure

is connected

