HMN M2 El-tip Gebrauchsanweisung Seite 25

Issues charging the chair.
1. If the chair wont charge after hours of trying.
Check that the outlet you are using has power in it, and that it is turned on.
2. The chair won't start charging, and the light indicating charging on the hand control is
not blinking.
At the top and to the right on the hand control is a light indicating charging status. This light will blink if the
battery is charging.
At first when you plug the wire for charging in to an outlet this light will not blink, it will just light up. After
some time the light will start to blink, and this indicates that the chair is charging. The reason some time
might pass before it starts charging is that the system is prepping the battery to receive power. This might
take extra time if the battery is cold, or the chair is very low on power.
Contact HMN if the problem persists.
Periodic errors.
1. The chair won't charge every attempt.
In case of charging failure, it may be a cable that is not correctly/properly plugged in.
Check that all cables are correctly inserted, if the problem persists contact HMN.
3. The charging light on the hand control is not
lighting up or blinking even if the chair is plugged
in to an outlet.
Check that the charging wire connected to the control box
is correctly plugged in. Check that the red locking ring is
mounted inside the plug on the control box. This issue is
normally because the charging wire or the locking ring is
incorrectly mounted. It can also be a faulty battery.
If the red locking ring is mounted correctly it can be seen
through the plug like on the picture to the left:
22
HMN
www. dk
.
HMN a/s