Carbest RW MOTION Benutzerhandbuch Seite 6

CARBEST l Safety glass sliding window RWMotion| 31650 - 31664
1.
Make sure that the e x isting wall cutout on your vehicle matches the
specified cutout dimension of the window.
Detail
Art. no.
W x H (mm)
500 x 300 31657
31650
500 x 350
500 x 450 31654
31653
600 x 350
600 x 450 31658
700 x 300 31659
31660
700 x 400
700 x 450 31661
2. Thoroughly clean the inside of the outer frame and the entire area around the wall cutout. The surfaces must be clean and
free of dust and grease. The surfaces must be clean, dust-free and grease-free.
3. Please apply sealant evenly and as thick as your thumb to the
inside of the outer frame.
Recommendation:
DEKAseal 8936 or SikaLastomer 710
ATTENTION!
Follow the sealant manufacturer's instructions!
4. Position the outer frame centrically in the wall cutout in terms of
height and width and press the frame carefully against the Vehicle
wall so that the sealant can be distributed evenly.
While one person holds and secures the window frame from the
outside, the second person should screw the supplied inner mounting
frame in place from the inside using the screws provided.
CAUTION: Do not tighten the screws too tightly!
5. Insert the black rubber cover to conceal the screws.
6. Remove the white PVC strip and align the blackout system.
Note:
Attach the pleated blind to the bottom and the mosquito net to the top.
7. To install the combination blind with the countersunk screw over
the mounting groove on the car body, you will need to drill a hole.
You must install a 23 x 14 x 20 mm mounting piece under each
screw hole.
8. Reattach the white PVC strip to the inner frame.
9. Peel the protective film off the window frame and remove the
plugs from the water drains on the underside of the frame.
Detail
Art. no.
W x H (mm)
800 x 340 31656
31651
800 x 400
800 x 450 31655
31662
900 x 450
900 x 500 31663
960 x 450 31652
31664
1000 x 500
6
DE
EN
IT
ES
FR
NL
FI
DK
SE