GreenWorks GD24X2TX Bedienungshandbuch Seite 11

Problem Possible
Cause
The line Lines are wel-
does not ded to them-
extend. selves.
Not enough line
on the spool.
Lines are worn
and too short.
Lines are tan-
gled on the
spool.
The line The machine is
keeps used incorrectly.
breaking.
The grass Cut tall grass at
winds ground level.
around
the trim-
mer head
and motor
housing.
The line The cut-off
does not blade becomes
cut well. dull.
Vibration The line is worn
increases down at one
obviously. side and not ex-
tended in time.
8 TECHNICAL DATA
Voltage 2x24 V
No load speed 6000±10%min
mer),6400 ±10%min
ter)
Cutting head Bump feed / Brush cutter blade
Cutting line di- 2.0 mm
ameter
Cutting path di- 356 / 406 mm (Grass trimmer),
ameter 254mm (Brush cutter)
English
Solution
Lubricate with silicone
spray.
Install more line.
Extend the line.
1. Remove the lines
from the spool.
2. Wind the lines.
1. Cut with the tip of
the line, avoid stones,
walls and other hard
objects.
2. Advance the cutting
line regularly to keep
full cutting width.
1. Cut tall grass from
the top down.
2. Remove no more
than 20 cm in each
pass to prevent wrap-
ping.
Sharpen the cut-off
blade with a file or re-
place it.
Make sure that the
line on both sides is
equal. Extend the line.
-1
(Grass trim-
-1
(Brush cut-
Weight (without 4.1 kg
battery pack)
Battery model G24B2/G24B4 and other BAG
series
Charger model G24C/G24X2UC4 and other CAG
series
Grass trimmer Measured
sound pressure
level
Guaranteed
sound power
level
Vibration
Brush cutter Measured
sound pressure
level
Guaranteed
sound power
level
Vibration
96 dB. Noise value. (Grass trimmer)
XX
96 dB. Noise value. (Brush cutter)
9 WARRANTY
(The full warranty terms and conditions can be found
on Greenworks website www.greenworkstools.eu)
The Greenworks warranty is 3 years on the product,
and 2 years on batteries (consumer/private usage)
from the date of purchase. This warranty covers
manufacturing faults. A faulty product under warranty
might be either repaired or replaced. A unit that has
been misused or used in other ways then described
in the owner's manual might be rejected for warranty.
Normal wear, and wear parts are not considered as
warranty. The original manufacturer warranty is not
affected by any additional warranty offered by a dealer
or retailer.
A faulty product must be returned to the point of
purchase in order to claim for warranty, together with
the proof of purchase (receipt).
10 EC DECLARATION OF CONFORMITY
Name and address of the manufacturer:
9
EN
L =87.9 dB(A),
PA
K = 3 dB(A)
pA
L = 96 dB(A)
WA.d
2
4.24 m/s ,
2
k=1.5 m/s
L =90.4dB(A),
PA
K= 3 dB(A)
L =96 dB(A)
WA.d
2
4.24 m/s ,
2
k=1.5 m/s