Dell PowerEdge 750 Handbuch Seite 2

F3043am0.fm Page 2 Friday, December 12, 2003 4:44 PM
9
Place the cover over the sides of the chassis, and slide the cover forward until it snaps
into place.
10
Tighten the two captive screws at the back of the system to secure the cover.
Figure 1-1. Installing the Optional Diskette Drive
bracket release lever
hard drive 1
11
Reconnect the system to the electrical outlet, and turn on the system.
12
If applicable, replace the bezel.
Align the hole in the left-side bezel securing tab with the tab on the front panel.
a
While rotating the bezel toward the front panel, slide the bezel toward the key lock
b
until the bezel snaps into place.
____________________
Information in this document is subject to change without notice.
© 2003 Dell Inc. All rights reserved. Printed in the U.S.A.
Reproduction in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden.
Trademarks used in this text: Dell and the DELL logo are trademarks of Dell Inc.
Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names
or their products. Dell Inc. disclaims any proprietary interest in trademarks and trade names other than its own.
diskette drive
mounting holes (4)
retaining pins (4)