Dell Networking S5000 Handbuch Zum Einstieg Seite 40

S5000 Console RJ-45 to RJ-45
Port Rollover Cable
Signal RJ-45 Pinout
CTS 8
Accessing the USB-B Console Port
The terminal settings are the same for the USB-B port and the console port:
• 9600 baud rate
• No parity
• 8 data bits
• 1 stop bit
• No flow control
When you connect the USB-B port, it becomes the primary connection and, when the
system is connected, it sends all messages to the USB-B drive.
Figure 24. USB-B Console Port Connector
1. Power on the PC.
2. Install the necessary USB device drivers (you will need an Internet connection). For
assistance, contact Dell Networking Technical Support.
3. Connect the USB-A end of cable into an available USB port on the PC.
4. Connect the USB-B end of cable into the USB-B console port on the S5000.
5. Power on the S5000.
6. Open your terminal software emulation program to access the S5000.
7. Set the terminal connection settings. Use these settings.
38
RJ-45 to RJ-45 RJ-45 to DB-9
Rollover Cable Adapter
RJ-45 Pinout DB-9 Pin
1 7
Terminal Server
Device
Signal
RTS