Closing The Door; Technical Data; Installation - AEG A51900GSW0 Benutzerinformation

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.

TECHNICAL DATA

Dimension of the recess
Rising Time
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.

INSTALLATION

WARNING!
Read the "Safety Information" carefully for your safety and correct operation of the ap-
pliance before installing the appliance.
Location
The appliance should be installed well away from sources of heat such as radiators, boil-
ers, direct sunlight etc. Ensure that air can circulate freely around the back of the cabi-
net. To ensure best performance, if the appliance is positioned below an overhanging
wall unit, the minimum distance between the top of the cabinet and the wall unit must
be at least 100 mm . Ideally, however, the appliance should not be positioned below over-
hanging wall units. Accurate levelling is ensured by one or more adjustable feet at the
base of the cabinet.
If the cabinet is placed in a corner and the side with the hinges facing the wall, the dis-
tance between the wall and the cabinet must be at least 10 mm to allow the door to
open enough so that the shelves can be removed.
WARNING!
It must be possible to disconnect the appliance from the mains power supply; the plug
must therefore be easily accessible after installation.
Height
Width
Depth
Technical data
1600 mm
600 mm
630 mm
35 h
13