Closing The Door; Technical Data - AEG AGS58800S0 Benutzerinformation

Problem
The temperature in the
freezer is too low.
The temperature in the
freezer is too high.
There is too much frost.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.

TECHNICAL DATA

Dimension of the recess
Rising Time
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.
Possible cause
The FROSTMATIC function is
switched on.
The temperature regulator is
not set correctly.
The FROSTMATIC function is
switched on.
The temperature regulator is
not set correctly.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too
high.
Many products are stored at
the same time.
Products are too near to each
other.
Food is not wrapped correctly.
The door is not closed correctly. Refer to "Closing the door".
The temperature regulator is
not set correctly.
Height
Width
Depth
Technical data
Solution
Refer to "FROSTMATIC function".
Set a higher temperature.
Refer to "FROSTMATIC function".
Set a lower temperature.
Let the product temperature de-
crease to room temperature be-
fore storage.
Store less products at the same
time.
Store products so that there is
cold air circulation.
Wrap the food correctly.
Set a higher temperature.
880 mm
560 mm
550 mm
20 h
13