Closing The Door; Installation; Ventilation Requirements - AEG AGN71200F1 Benutzerinformation

28 www.aeg.com
Problem

8.2 Closing the door

1. Clean the door gaskets.

9. INSTALLATION

9.1 Location
To ensure best performance, install the
appliance well away from sources of heat
such as radiators, boilers, direct sunlight
etc. Make sure that air can circulate freely
around the back of the cabinet.
9.2 Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Climate
class
SN
N
ST
T
If the advice does not lead
to the desired result, call the
nearest Authorized Service
Centre.
WARNING!
Refer to Safety chapters.
Refer to the assembly
instructions for the
installation.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
Possible cause
There is no cold air circula-
tion in the appliance.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.

9.3 Ventilation requirements

The airflow behind the appliance must
be sufficient.
Solution
Make sure that there is cold
air circulation in the appli-
ance.
Some functional problems
might occur for some types
of models when operating
outside of that range. The
correct operation can only
be guaranteed within the
specified temperature
range. If you have any
doubts regarding where to
install the appliance, please
turn to the vendor, to our
customer service or to the
nearest Service Centre
min.
5 cm
2
200 cm
min.
2
200 cm