Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Set up TTC450 Pro
Step 6 ： Test
Make sure the emergency stop switch is popped up, plug in the power.If the screen lights up, the power on is
normal. If the screen does not light up, after power off, exchange the screen line position to reboot.
Click the "Control" button and move XY-axis to the bottom left corner of the machine.
Click XY Clear and Z Clear .Then move the XY axis away from the corner.
Click "NEXT", click "Home" to return to corner.XYZ axis will return to the bottom left corner of the machine.
Click "Spindle" to rotate the spindle. Click "Spindle" again to stop the spindle.
Z+
Y+
X-
X+
Y-
Z-
Z+
Z-
Y+
X-
X+
Y-
10
Operation Guide
Step 1 ： Installation of milling cutter
Note: The clamping length of the cutter is approximately 1/2 or 1/3 of the total length of the cutter.
V-Bit 0.393 Inch(10mm)
90 degree
Straight cut
0.125 Inch(3.175mm)
Millcutter
ER11 chuck
0.125 Inch(3.175mm)
CNC tool
30 degree carving cutter 0.125 Inch
(3.175MM diameter，0.1 end)
Cutting
Ovreall
Flute
Explanatory note.
length
length
count
V-Bit tools are generally used
for engraving V-style letters.
They could also be used to
11mm
50mm
2
remove the background and
leave areas flat on the fac of
the material.
Straight cut can be used for
20mm
38mm
2
Roughing, Area Clearance,
Cutouts, Inlays and Profiling.
Designed for routing where
upward chip removal, tool
12mm
39mm
2
rigidity, long life and high
quality finish is desired.
15mm
27mm
1
Use for fine detail engraving.
11
EN
Werbung
