Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operation Guide
Step 6 ： Select File Engraving
Select the file and start engraving.
Note: Set appropriate feed rates based on the hardness of the material and tool.
Option to start or stop the program
Click Adjustment button you can
change the rate and speed
Resume
Suspension and continuation
Stop
End of carving
16
FAQ
1.Q&A Motherboard
Q1: Motor or limit switch not working.
A1: Please confirm that the motherboard wiring is correct, as shown in the figure-1, in the case of correct
installation, ensure that the wiring is not loose.
2. Q&A of Power supply
Q1: No response after power-on.
A1: Pls check if cable is loose and plug it again.
A2: Check if there is voltage at the power socket interface, and if there is current at the power input. If the former
does not have the latter, it is a problem with the power supply.
A3: Check if the power socket is loose and the power indicator is on. Please check if the power indicator of the
chassis is on. If the light is on but the machine is not working properly, check whether the indicator light on
the motherboard is on. If it is not lit, the output power cable is loose, or the motherboard has a problem.
figure-1
figure-2
17
EN
Werbung
