Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Storing
If the dehumidifier will not be used for a long period of time, take the following steps:
1. Run the dehumidifier in Air Purification Mode for a few hours to dry the internals as much as
possible. This will help to minimise the chance of mould growing inside the dehumidifier during
long term storage.
2. Remove the plug from the socket and empty the water tank. Allow the water tank and the
dehumidifier to dry completely, this can take a couple of days.
3. Use the cable tidy on the back of the dehumidifier to wrap the cable away.
4. Clean the filter and store the device in a dust-free location away from direct sunlight, preferably
covered with a sheet of plastic.
Troubleshooting
If you come across a problem with your dehumidifier, check the table below and try the suggestions. If
the problem persists, contact Meaco or your original seller.
Error
Dehumidifier indicator is not displayed
Buttons do not beep when pressed
There are no lights on the display
The dehumidifier does not dehumidify /
collects little water
[EN]
The dehumidifier is checking the humidity level to see if it has
risen above the set target.
The dehumidifier is in Night Mode. To remove Night Mode
press the Night Mode button twice.
The dehumidifier is in Night Mode. To remove Night Mode
press the Night Mode button twice.
• The temperature is either too cold or too warm, make sure
the dehumidifier is being used in an environment between
5°C and 35°C.
• The humidity level is already very low – below 45%RH
the dehumidifier will not collect much water as there isn't
enough moisture in the environment.
• The target humidity level is higher than the actual humidity
level. Use the Smart Humidity Mode button to reduce the
target humidity level.
• Clean the dust filter and/or replace the H13 HEPA filter. If
these are dirty they will block the airflow and prevent the
dehumidifier from dehumidifying.
• The dehumidifier is in Air Purification Mode. See page 11 for
more information.
18
Action
Werbung
