Herunterladen Diese Seite drucken

Meaco MeacoDry Arete Two 10L Bedienungsanleitung Seite 89

Luftentfeuchter und luftreiniger

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

If the humidity level has increased more than 3% above the target, the compressor will turn
on and the dehumidifier will start to run again – the dehumidifying indicator will be solid. If the
humidity level is within 3% of the target, the dehumidifier will go back to sleep and check the
humidity level in another 30 minutes.
If the current humidity level is within 15% of the target humidity level, the dehumidifier
will default to low fan speed. If the current humidity level is 15% or more above the target
humidity level the dehumidifier will default to medium fan speed.
Air Purification Mode: Hold the smart humidity button down for 2 seconds to enter Air
Purification Mode
– the air purifier indicator will show on the display in the top left corner.
In Air Purification Mode the dehumidifier will not dehumidify, it will simply purify the air. This
mode is useful during the months when dehumidification is not required. To remove Air
Purification Mode, hold the smart humidity button down for 2 seconds – this will take you
back to Smart Humidity Mode.
Important! If a H13 HEPA filter is installed, the dehumidifier will always be purifying the air
– it does not specifically need to be in Air Purification Mode.
Smart Laundry Mode: Press the Smart Laundry Mode button once to enter Smart Laundry
Mode. In this mode, the dehumidifier will default to a target humidity of
35%RH
and high
fan speed. The laundry indicator will show on the display. The dehumidifier will run in Smart
Laundry Mode for 6 hours, after 6 hours the dehumidifier will turn off. To adjust the amount of
time left in Smart Laundry Mode, press the timer button. To stop Smart Laundry Mode press
the Smart Humidity button or turn the dehumidifier off and on again.
If the dehumidifier reaches a humidity level of
32%RH
before the 6 hours is up, the
compressor will turn off to stop the air from becoming too dry, but the fan will continue to
run. The dehumidifying indicator will turn off. If the relative humidity increases to 38%RH the
compressor will turn back on. It will do this until the 6-hour timer is up.
Hold the smart laundry button for 2 seconds to enter WiFi mode
. For further instructions
see page 5.
Timer: Use the timer button to set an ON or OFF timer. To remove either the ON or OFF
timer, press the timer button until you reach '00 hrs'.
Timer On: When the dehumidifier is in standby mode, use the timer button to move between
1 and 24 hours in which the dehumidifier will turn on. The interface will display the number of
hours in which the dehumidifier will turn on e.g. 'on 03 hr'. Please leave a one second pause
for the timer to be set.
Timer Off: When the dehumidifier is on, use the timer button to move between 1 and 24
hours in which the dehumidifier will turn off. The interface will display the number of hours in
which the dehumidifier will turn off e.g. '03 hr' and 'OFF'. If in Night Mode, the interface will
turn off. Please leave a one second pause for the timer to be set.
11
[EN]

Werbung

loading

Diese Anleitung auch für:

Meacodry arete two 12l