Silvercrest SFR 3 A1 Bedienungsanleitung Seite 65

Inserting batteries
1) Pull off the battery compartment cover 2 .
2) Insert the batteries as shown in the polarity diagram in
the battery compartment .
3) Slide the battery compartment cover 2 back on so
that it clicks into place .
Usage
Note: (1) This lint remover can damage structured
fabrics or very soft materials such as angora . Therefore,
always test the lint remover on an inconspicuous part of
the garment and turn the transparent part of the spacer 5
first to the level " " and then push the On/Off switch/
Speed switch 1 to speed level 1 . The appliance now
runs at speed level 1 . In this way you can gently test
whether the setting is sufficient for the garment without
damaging it . (2) This appliance should not be brought
into contact with moisture . Therefore, do not use the
lint remover on moist fabrics .
1) Lay the garment on a flat surface, such as an ironing
board . Ensure that the surface to be processed has no
wrinkles . Otherwise, the garment could be damaged .
2) Turn the spacer 5 to the desired position or remove
it completely (see Chapter "Removing/replacing the
spacer"):
–
" " for large bobbles and coarse textiles (large
distance to the cutter knives)
■ 62 │ GB │ MT