Renson Lagune Montageanleitung Seite 55

MONTAGEANWEISUNGEN • CONSTRUCTION INSTRUCTIONS
5.1 • Step 18: Sidefix
EN
9 • Take the triangle ➈ from the cardboard pipe and bring the screen loop into the screen slot of the Sidefix
10 • Slide the screen cord in the fabric slot (DETAIL I1). 10 11 12
11 • Cut the screen cord to the following length: length Sidefix 10 11 12
➈
12 • Roll the triangle up and place this temporarily on the upper surface of the Sidefix
13 • Position the Sidefix ® box
14 • Bring the motor cable through the hole Ø 57
it comes out at the bottom of the wall box. Make the required connection.
15 • Position the Sidefix box
®
Slide the adjustable wall side channel
(DETAIL K) and the shank of the Sidefix box on the column side (DETAIL I & M) with screws (cross-headed screwdriver)
12 13
16 • Align the adjustable wall side channel
Measure the space above and below, and after correction screw the screws to in the seat of the adjustable wall side channel
Caution! Do not turn the screw further (Allen key 4), otherwise the space between will change again (DETAIL L).
DETAIL I
L L
➃
.
w w w r e n s o n
- integration part 4
®
➉
with a fork-lift truck at the correct height (see Lagune
➇
provided (DETAIL K) of the adjustable wall side channel
➉
between the adjustable wall side channel
➃
against the side of the Sidefix
➃
parallel with the column (DETAIL J).
➈
10
14
DETAIL J
10
=
=
.
e u
Lagune
S U N P R OT E C T IO N -S C R E E N S
➉
® box - 20 mm (scissors).
➉
box
®
passage height ➌)(DETAIL J)
®
➃
and the column (DETAIL J).
11 12 13
➉
box and fix the shank of the Sidefix
®
14
11 12 13
U
11 12 13
55
®
box ➉ (DETAIL I1).
®
.
➃
and push the cable until
box on the wall side
®
W
DETAIL I1
➈
10 11 12
DETAIL L
TPD-LAG-06MI-054-20100915-DE EN
➃
.
U
➃
➁