Renson Lagune Montageanleitung Seite 19

MONTAGEANWEISUNGEN • CONSTRUCTION INSTRUCTIONS
5.1 • Determining the position of and placing the assembly feet
+ fixing invisible assembly feet with columns
1 • Mark off the plumb lines (DETAIL A), the Lagune width and Lagune depth (laser, chalk line).
Check the squareness in relation to ZERO LEVEL.
2 • Mark off where the assembly feet will be fitted depending on the type of assembly foot. Holes of at least 500 mm depth must be provided
for the cast assembly feet. The volume be must determined on the basis of the surface type.
Provide a stable surface under the assembly feet.
3 • The visible assembly feet and cast assembly feet are fixed in 5.1 step 7 point 7. The invisible assembly feet are fitted now.
They are fixed with two anchors M16
Then the column is placed over the foot and fixed to the foot from three sides with round headed screw (Allen key 5).
Sichtbarer Montagefuss
Visible assembly foot
45 105
160
195
Eingegossener Montagefuss
Cast assembly foot
105
9
Lagune
Lagune
.
w w w r e n s o n
➀
each (box wrench 24 with 300 mm extension).
Lagune Breite
®
Lagune width
®


Breite
®
width
®
.
e u
Lagune
S U N P R OT E C T IO N -S C R E E N S
Unsichtbarer Montagefuss
Invisible assembly foot
105
52.5
19
TPD-LAG-06MI-018-20100915-DE EN
®
G
G
G
G
➀
➀
Lagune Breite
®
Lagune width
®