Renson Lagune Montageanleitung Seite 51

MONTAGEANWEISUNGEN • CONSTRUCTION INSTRUCTIONS
5.1 • Step 18: Sidefix
EN
6 • Fit the rivnuts on the column side: (X)
Position the drilling template
Caution! The top of the drilling template
Caution! Depending on the front beam height (160 or 120 mm) two drilling templates
Extra check: the bottom surface of the front beam and the horizontal slot in the drilling template must be in one plane.
Mark the holes of the drilling template (pencil) on the column and remove the drilling template
Caution! The drawing refers to a Sidefix
➅
Predrill Ø3 then enlarge to Ø 9.
Sink the holes Ø 9 so the rivnut can be assembled flat (countersink).
Fit the rivnuts (riveter). V
Unterseite
Frontbalken
Bottom surface
front beam
.
w w w r e n s o n
- integration part 2
®
➄
supplied on the column according to DETAIL C.
➄ serves as a stop against the bottom surface of the water channel (DETAIL C).
left integration. In this case one must use the holes
®
V
DETAIL C
➅
V
.
e u
Lagune
S U N P R OT E C T IO N -S C R E E N S
➄
are available (DETAIL D).
➅
➄
51
®
➄
.
dans le modèle de perforation
DETAIL D
TPD-LAG-06MI-050-20100915-DE EN
➄
.