Method Of Use - Timago Power-Tim Benutzerhandbuch

• Put charger plug into charging port located in control module:
• Put charger plug into charging port in control module first. Then connect
charger to power supply (outlet)
• Check if circuit connec�on is correct.
• Do not modify charging circuit connec�on.
• To avoid fire or burnout, do not unplug charging circuit while batery is
charging.
D. METHOD OF USE
• To use wheelchair set up engine levers to a chosen ride mode.
Note! Do not switch ride mode during drive on eleva�on.
• Push power buton on control panel to check correct opera�on of brakes.
Brakes work correctly if you cannot push the wheelchair. Otherwise, contact
the Seller.
• Tilt footrest and sit comfortably on a wheelchair seat. Lower the footrest
back to original posi�on.
Note! Do not use footrest as assurance during si�ng down or standing up from
a wheelchair. This may cause wheelchair to �lt and fall down.
• Sit on a wheelchair and turn on power buton on control panel. LED lamp
will light up. Joys�ck should be in neutral posi�on.
• During first usage exercise cau�on. Before driving check if parking brakes is
released. You can control speed and direc�on with joys�ck. The
electromagne�c brake will get release a�er slightly pushing joys�ck in ride
direc�on. To speed up wheelchair push joys�ck futher away from its neutral
posi�on and to slow down – bring it closers.
• To stop a wheelchair, let go of the joys�ck. Pressing power buton or rapidly
le�ng go of the joys�ck will stop the wheelchair.
80