Timago POWER-TIM Benutzerhandbuch Seite 76

• Press sides of the seat so all the parts of wheelchair can fit together.
Note! Check the bars that supports batery weight are correctly unfolded.
They're located at the back of the wheelchair.
• Unfolding backrest: catch handles with hands, li� up backrest �ll you hear
clicking sound of blocking pin.
• Folding backrest: Press and hold seat clamps. Check if blocking pins are
unlocked and then lower the backrest.
Note! Do not keep fingers close to backrest hingers.
• Footrest assembly: Put assembly element of footrest into opening in front
frame of wheelchair. Rotate footrest inwards to block footrest levers (look:
picture 3-5). Make sure footrest frame is locked in correct posi�on.
• An�-�pping wheels assembly: Put an�-�pping wheels into moun�ng
openings at the back of wheelchair. Put blocking clip (look: picture 6)
through openings to secure and lock wheels in place (look: picture 7).
• Regula�on of control module posi�on: Regula�on should be only done
while si�ng in wheelchair. Loosen moun�ng screw and move moun�ng
bracket forward or backward to set it to appropriate length, then �ghten the
screw.
76