To Clean The Product - Meec Tools 029883 Bedienungsanleitung

1
Put the sealing washer into the applicable hose
EN
adapter and tighten the hose adapter onto the
pressure pipe. (Figure 4)
SV
2
Attach the hose or pipe to the hose adapter and
safety it with a hose clamp.
NO
4 Operation
PL
Caution! Do not lift the product by the cable, outlet
pipe, or hose.
DE
4.1 To do before the first use
● Attach a rope to the handle before the first use. Use
FI
the rope to lift and balance the product while in the
water.
FR
4.2 To do before each use
Caution! To prevent electrical shock and damage
NL
to the product, make sure that water cannot come into
the battery compartment.
1
Make sure that the battery is fully charged.
2
Make sure that the pressure pipe is correctly
connected.
4.3 To operate the product
Caution! Make sure that the suction opening is not
blocked by dirt, debris, or foreign objects.
1
Put the product into the water.
2
Install a battery to the battery compartment. Make
sure to close the battery cover correctly.
3
Hang the battery compartment on the hook or
install it on 2 screws.
4
Push the power button to start the product.
Note! Push and hold the power button to set the opera-
tion time to 5, 10 or 15 minutes.
5
To stop the product, push the power button.
8
5 Transportation
● Do not lift the product by the power cable or the
pressure hose.
● Disconnect the battery before you transport the
product.
6 Storage
● If the product will not be used for a long period of
time, remove the battery.
● Put the product in a clean and dry area, out of direct
sunlight and where children and pets do not have
access.
7 Maintenance
Caution! Disconnect the battery before you
assemble, disassemble, clean, or do maintenance to the
product.
● Clean the product after each use.
● Clean the sludge from the bottom of the product
regularly.
7.1

To clean the product

● Clean the product with clear water. If necessary, use a
mild detergent.