Etac R82 Crocodile 1 AT Benutzerhandbuch Seite 47

Safety
Signs, symbols and instructions placed on this product must never be covered or removed and must
remain present and clearly legible throughout the entire lifetime of the product. Immediately replace or
repair illegible or damaged signs, symbols and instructions. Contact your local dealer for instructions.
Any adverse event in relation to the device must be reported to your local dealer and the national compe-
tent authority in a timely manner. The local dealer will forward information to manufacturer.
Caregiver
• Read the "User manual" carefully before use
and keep it for future reference. Incorrect use
of this product may cause serious injury to
the user
• This product contains small parts which could
present a choking hazard if removed from
their intended placing.
• Settings and adjustments to the product or
accessories are only to be made by persons
who have read the user guide.
• Always use the correct lifting techniques and
aids for this purpose
• Never leave the user unattended in this
product. Ensure permanent supervision by a
caregiver
• Repair/replacements must only be made
using new original R82 spare parts and
fittings and carried out in accordance with the
guidelines and service intervals prescribed by
the supplier
• If there is any doubt as to the continued safe
use of your R82 product or if any parts should
fail, stop using the product immediately and
contact your local dealer as soon as possible
• Ensure that moving parts does not squeeze or
trap body parts when adjusting them
• Ensure that body parts are not trapped
in openings for mounting of supports/
accessories.
• Ensure fingers are not trapped when adjusting
the handle position (ensure free clearance
distance >25 mm)
• Be aware of any MAX mark indications before
adjustment
Environment
• Observe the surface temperature on the
product, before placing an user in it. This
goes especially for users with insensitive skin
as they cannot feel the heat. If the surface
temperature is above 41°C then allow the
product to cool before use
• Use this product on a level surface without
any obstacles. Be aware of reduced
maneuverability on slippery surfaces
• When using on inclines, please refer to
measurements
User
• If the user is close to the max. load limit
and/or has a lot of involuntary movements,
e.g. rocking, a larger size with a higher max.
load or a different R82 product should be
EN
considered
• Be aware of the user's capacity to exceed
walking speed or ability to complete sharp
turns, which may cause the product to become
unstable
Product
• Carry out all positional adjustments on the
product and accessories and ensure that
all knobs, screws and buckles are securely
fastened before use. Keep all tools out of the
reach of children
• Activate the brakes before placing the user
into the product
• Ensure the stability of the product is
maintained before placing the user in it.
• Ensure the castors are fully-functional and
secure before use
• Inspect the product and all of its accessories
and replace any worn out parts before use
• This product is not to be occupied in a motor
vehicle. The user must be positioned in a
vehicle seat and the product must be stored in
a luggage compartment
• The user must not occupy the product while
it is being transported into or out of a vehicle
by a lift
• Unoccupied device is suitable for land and air
transport
• To be in compliance with ISO 11999-2 the
device size 2/2 AT & 3/3 AT shall have the
decelerating brake (running brake) accessory
mounted.
• To be in compliance with ISO 11999-2 the
device size 2/2 AT & 3/3 AT shall have the
parking brake accessory mounted when
used outdoor or in combination with the seat
accessories.
48
etac.com