EuroLite LED IP Mega PIX Strobe 714 Swing Bedienungsanleitung Seite 32

PROG
PROG-
Auto
Speed
Test
DmxCHs
Option
Smooth
LCD inverse
Back light
Key Lock
Setting
Reset
English
English
Item No.
INFO
Ver.
Temp.
RDM
This device supports RDM (Remote Device Management), which makes remote control of devices
connected to the DMX bus possible. ANSI E1.20-2006 by ESTA specifies the RDM standard as an extension
of the DMX512 protocol. RDM simplifies device configuration as manual settings like adjusting the DMX
starting address are no longer needed. RDM is integrated in DMX without influencing the connections. The
RDM data is transmitted via the standard XLR pins 1 and 2 – new DMX cables are not necessary. RDM-
ready and conventional DMX devices can be operated in one DMX line. The RDM protocol sends own
packages in the DMX512 data feed and does not influence conventional devices. DMX splitters, however,
must support RDM. Which parameters can be called up via RDM depends on the RDM controller used.
Master/slave operation
Several devices may be interconnected (max. 12). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
1 Configure all slave units before connecting the master unit. Set the DMX starting address 001 for all
slave devices.
2 Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
3 Select the desired setting (Auto mode) at the master unit. The interconnected devices will now operate
synchronously.
Pr 01 – 10 – 45 Auto programs, 0 - 45
Sp 01–08–16 Auto programs speed, slow > fast
Auto test
8CH 8-channel mode
9CH 9-channel mode
11CH 11-channel mode
12CH 12-channel mode
17CH 17-channel mode
18CH 18-channel mode
71CH 71-channel mode
ON/OFF Dimming behaviour
Display reverse 180°, ON,
ON/OFF
Display normal, OFF
Display off after 45s, On,
ON/OFF
Display always, OFF
Display is locked with ON,
ON/OFF Press MODE ENTER together 3 times to unlock
Display is unlocked with OFF
Reset to factory settings, (press ENTER button)
System language
Device no.
Vx.xx Current software version
Xx°C Internal temperature of the device
32/44 00160417, Version 1.0