Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Adjusting the splitter wedge height
The splitter wedge height can be adjusted to the log diameter. To adjust it height pull its lever from
the notch and adjust it to the desired position – as indicated on a sticker - until it jumps into the new
notch. The adjusting lever moves together with the wedge:
Splitting the log
Place the log on the feed table and push it against the stop. Check that both protective cages are
lowered and then cut the log.
7. Maintenance
7.1.
Maintenance
Clean the machine and make sure that all saw dust is removed. Keep the machine indoors if possible.
If the machine is stored outside, it must be covered with tarpaulin or cover.
Pay attention to the value of the oil filter pressure gauge during use. The oil must be cleaned or
replaced if the value reaches to the red line. Please especially note that hydraulic oil must be
distinguished between winter oil and summer oil.
7.2.
Chainsaw Bar
Check before each use that there is no damage or similar to the chainsaw bar. Make sure to always
work with a sharp chain, as this makes work much easier.
7.3.
Adjusting the chain
Release the two bolts on the saw bar and adjust the tension screw. Tighten the screw to tighten the
chain and vice versa. Then tighten the two bolts on the saw bar. You should be able to lift the chain
about 6.4mm to 13mm from the saw bar. Remember not to tighten the chain too tight.
8. Disposing of used devices
Do not dispose of this device in municipal waste systems. Hand it over to an electric and electrical device
recycling and collection point. Check the symbol on the product, instruction manual and packaging. The plastics
Werbung
