DeFelsko PosiTector DPM Gebrauchsanweisung Seite 6

Alarm
The PosiTector DPM can automatically alert the user when
current climatic conditions exceed pre-set values. When
selected, the Alarm icon
screen.
Standard models will alert the user when the surface
temperature is less than 3°C (5°F) above the dew point
temperature. Enable by selecting the tick box.
Advanced models allow the user to set up custom alarm
conditions for each reading in a dataset. When connected to
WiFi, Advanced models can also send alerts via email.
Units
Converts the displayed units for temperature and wind velocity.
Temperature (all models): Celsius (°C) or Fahrenheit (°F)
Velocity (DPM A only): m/s, ft/s, km/h, mph, or kn.
Reset
Memory = OFF
Auto Log = OFF
Trend Chart = None
Auto Dim = ON
Display = None
Perform a more thorough Hard Reset as follows:
1. Power down the Gage and wait 5 seconds.
2. Simultaneously press and hold the
until the Reset symbol
This returns the Gage to a known, "out-of-the-box" condition.
Alarm Mode
is displayed at the the top of the
Setup Menu
Bluetooth Classic = OFF
WiFi & Access Point = OFF
Keyboard & Stream = OFF
Anemometer = ON
appears.
4
and buttons