Ispring RCC Serie Installationsanleitung & Benutzerhandbuch Seite 25

Housing Wrench for Stages 1, 2, and 3 Housings (#AWR2): A housing wrench is used to
screw on and unscrew the membrane housing cap and lter housings.
Ice Maker Kit (#ICEK): This Add-on kit allows you to run water from the system to your fridge
ice maker or fridge water dispenser.
Leak Stopper (#ALS1): This device cuts o the water supply when it detects a leak, as the
sponge absorbs water.
Membrane Housing and Cap (#NW12): Horizontal housing for the RO membrane.
Membrane Housing O-Ring (#ORM): 2 1/2" O.D. The O-ring creates the seal between the
membrane housing and the cap.
Polypropylene (PP) Sediment Filter (#FP15): 1st stage. 5-micron 10" lter trapping dirt,
rust, and silt.
Post-Activated Carbon Filter (#FT15): This is the 5th stage. The nal polishing lter is before
the RO water reaches the drinking faucet.
ppm: Parts Per Million, mg/L.
Pressurized Holding Tank (#T32M): A 3.2-gallon tank that forces water to the drinking
faucet. Tanks are pre-pressurized to 7-10 psi when empty.
psi: Pounds Per Square Inch, a measure of water pressure.
Quick-connect Fitting: Easy-to-connect/disconnect tting. Tubing is inserted past the O-ring,
locked by the spider lock, and locking C-clip.
Reverse Osmosis (RO) Membrane (#MC1/MC2/MC7): 4th stage. A high rejection rate,
0.0001 microns, thin- lm composite (TFC), is essential for reverse osmosis.
Stage 1, 2, and 3 housing O-rings (#ORF): 3 5/8" O.D. O-rings create seals for the lter
housings.
Stage 1 See-Through PP Filter Housing (#HC12): This transparent housing for the sediment
lter allows visual inspection.
Stage 2 GAC Filter Housing (#HW12): Solid white housing that holds the stage 2 GAC lter.
Stage 3 CTO Filter Housing (#HW12): Solid white housing that holds the stage 3 CTO lter.
23