Step 8: Leak Stop Valve (Model #Als1) Installation - Ispring Rcc Serie Installationsanleitung & Benutzerhandbuch

Note: Leave enough tubing to be sure you can move the system and replace
lters when needed. You may adjust the connection sequence following the
instructions and reorganize the tubing.

Step 8: Leak Stop Valve (Model #ALS1) Installation

The Leak Stop Valve is a reusable mechanical leakage protector. It will shut down the feed
water whenever a water leakage is detected.
Step 8. a. Make sure the end of the tubing is cut square before connecting it to the tting.
Step 8. b. Follow the water ow direction indicated on the Leak Stop Valve to connect it to
the water inlet pipeline.
Step 8. c.
Tape the bottom of the Leak Stop Valve against the oor.
Pure Water
Outlet
Any Water Filtration
System
Note: Pad is for ONE TIME USE only.
In case of any leak incidence and the pad is expanded, please shut o incoming
water supply completely, x the leak, and replace the expanded pad before
turning the water supply back on.
14
Water Inlet
OUT IN
ALS1
Water out Water in
RO system Feed Water Adapter
OUT IN
Water Flow Direction
Tape the bottom
against the oor
Pad