Step 1: Installing Feed Water Adapter (Model #Afw43); Step 2: Installing Drinking Water Faucet - Ispring Rcc Serie Installationsanleitung & Benutzerhandbuch

Step 1: Installing Feed Water Adapter (Model #AFW43)

We recommend watching our video "How to Install a Feed Water Adapter for Reverse
Osmosis (RO) and Other Applications | iSpring AFW43" on YouTube for your reference.
Step 1. a. Turn o the Cold Water Shut-o Valve under the sink and open the kitchen faucet
to release pressure. Grab a towel or bucket to catch any water drips. Disconnect the kitchen
faucet connector pipe from the Cold Water Shut-o Valve.
Step 1. b. Install the AFW43 onto the Cold Water Shut O Valve and tighten it using a wrench
or pliers. Ensure the O-ring is seated inside the adaptor.
Step 1. c.
Reinstall the kitchen faucet connector pipe onto the male end of the AFW43. Turn
the handle of the AFW43 to the perpendicular OFF position. Slowly turn on the Cold Water
Shut-o Valve to ensure a proper seal.
Step 1. d. Connect the 1/4''
To Existing Faucet
1/2'' Bushing
To Water
System
Cold Water
Shut-O Valve
The included bushing can be threaded on either side of the AFW43 to t the 3/8'' COMP and
1/2'' NPT con guration.

Step 2: Installing Drinking Water Faucet

Step 2. a.
This drinking faucet installation kit includes a Top-mount Kit, a Bottom-mount
Kit, and a Faucet Bracket. If your kitchen sink does not have a faucet hole for the drinking
faucet, you can either drill one (Refer to How to Drill a Hole on Sink or Countertop below)
or use the enclosed Faucet Bracket (Refer to Option 3: Faucet Bracket below). Choose a
suitable location on the sink or countertop and install the drinking faucet on a at surface,
as shown in the image below.
08
RED tubing to the AFW43.
1/2''
1/2''
1/2''
3/8''
To Existing Faucet
3/8''
To Water
System
3/8'' Bushing
3/8''
Cold Water
Shut-O Valve
3/8" COMP
= 9/16" UNS