Technical Data; Replacing The Lamp; Closing The Door - AEG S92500CNM0 Benutzerinformation

16

Technical data

Problem
The temperature in the
wine cellar is too high.
The temperature in the
freezer is too high.
Upper or lower square is
shown in the temperature
Display.
dEMo appears on the Dis-
play.

Replacing the lamp

The appliance is equipped with a longlife LED interior light.
Only service is allowed to replace the lighting device. Contact your Service Center

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.
TECHNICAL DATA
Dimension of the recess
Rising Time
Voltage
Frequency
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.
Possible cause
The product temperature is too
high.
Many products are stored at the
same time.
There is no cold air circulation in
the appliance.
Products are too near to each
other.
An error has occurred in meas-
uring the temperature.
The appliance is in demonstra-
tion mode (dEMo).
Height
Width
Depth
Solution
Let the product temperature de-
crease to room temperature be-
fore storage.
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.
Store products so that there is
cold air circulation.
Call your service representative
(the cooling system will continue
to keep food products cold, but
temperature adjustment will not
be possible).
Keep pressed approximately 10
sec. the OK button since a long
sound of buzzer is heard and the
Display shut off for a short while:
appliance start works regularly.
1855 mm
545 mm
575 mm
25 h
230-240 V
50 Hz