CTEK 1046 Bedienungsanleitung Seite 3

HOW TO CHARGE
1. Connect the charger to the battery.
2. Connect the charger to the wall socket. The power lamp will indicate that the mains
cable is connected to the wall socket. The error lamp will indicate if the battery clamps
are incorrectly connected. The reverse polarity protection will ensure that the battery
or charger will not be damaged.
3. Press the MODE-button to select charging program.
4. Follow the 8-step display through the charging process.
The battery is ready to start the engine when STEP 4 is lit.
The battery is fully charged when STEP 7 is lit.
5. Stop charging at any time by disconnecting the mains cable from the wall socket.
READY TO USE
ERROR LAMP
MODE-
BUTTON
POWER
LAMP
TEMPERATURE
NORMAL AGM
SENSOR
BATTERY
BATTERY
INDICATOR
PROGRAM
PROGRAM
FULLY CHARGED
RECOND SUPPLY
PROGRAM
PROGRAM
EN • 5