Intex ECO5220 Bedienungsanleitung Seite 17

(329IO) MODEL ECO5220/5230 & 6220/6230 SALTWATER SYSTEM WITH E.C.O. ENGLISH 7.5" X 10.3" PANTONE 295U 05/23/2024
OPERATION INSTRUCTIONS
1. Turn on the filter pump.
2. Start up the unit:
Plug the power cord into the electrical outlet and test the RCD (circuit
breaker). Press button. Flashing code "00" appears on the electronic
control station's LED, indicating that the unit is ready to be programmed.
3. Set operating hours for Saltwater system:
With code "00" flashing, press
desired operating hours. See the "Operating Time
Table" for the required operating hours related to
each pool size. Pressing
from 01 to 12 hours maximum. If you have selected
too many hours keep pressing
The built-in timer will now activate your Saltwater
System, at the same time each day, for the number
of hours you have set.
NOTE: The Saltwater System will not operate if the filter pump is not operating. Make sure
to program your filter pump (or start it manually) for operation beginning 5 minutes before the
saltwater system and finishing 15 minutes after the saltwater system.
4. Lock keypad controls:
With the desired hour value showing, press
"beep". A green "WORKING" indicator on the control panel will light up
within a few seconds to indicate that the saltwater system has started
sodium hypochlorite production. Locking the control buttons into this
setting prevents unauthorized changing of the operating cycle.
NOTE: If you forget to lock the keypad controls, the system will
automatically lock it and start working 1 minute later.
5. Readjust operating time if necessary:
The operating hours can be re-adjusted if necessary. Press
until you hear a "beep" to unlock the keypad and the current
programmed time will flash. Repeat steps 3 to 4.
SAVE THESE INSTRUCTIONS
button to set the
will increase the time
to repeat the cycle.
button until you hear a
English
(1 to 12 hours max per cycle)
button
Page 17
329
A